5.5. Disabling the Cluster Software
It may become necessary to temporarily disable the cluster software on a cluster member. For example, if a cluster member experiences a hardware failure, you may want to reboot that member, but prevent it from rejoining the cluster to perform maintenance on the system.
Use the /sbin/chkconfig command to stop the member from joining the cluster at boot-up as follows:
# chkconfig --level 2345 rgmanager off # chkconfig --level 2345 gfs off # chkconfig --level 2345 clvmd off # chkconfig --level 2345 fenced off # chkconfig --level 2345 lock_gulmd off # chkconfig --level 2345 cman off # chkconfig --level 2345 ccsd off
Once the problems with the disabled cluster member have been resolved, use the following commands to allow the member to rejoin the cluster:
# chkconfig --level 2345 rgmanager on # chkconfig --level 2345 gfs on # chkconfig --level 2345 clvmd on # chkconfig --level 2345 fenced on # chkconfig --level 2345 lock_gulmd on # chkconfig --level 2345 cman on # chkconfig --level 2345 ccsd on
You can then reboot the member for the changes to take effect or run the following commands in the order shown to restart cluster software:
service ccsd start
service cman start (or service lock_gulmd start for GULM clusters)
service fenced start (DLM clusters only)
service clvmd start
service gfs start, if you are using Red Hat GFS
service rgmanager start