initramfs initramfs-linux.img followkernel

# See /boot/overlays/README for all available options
# For more options and information see
# http://www.raspberrypi.org/documentation/configuration/config-txt.md
# Some settings may impact device functionality. See link above for details

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
#goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
#overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
# hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

# uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800

# Uncomment some or all of these to enable the optional hardware interfaces
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

# Uncomment this to enable the lirc-rpi module
#dtoverlay=lirc-rpi

# Uncomment this if you need more current out your usb port. The default
# is 600 watts. This increases the current to 1200 watts. This only
# works on the RPi's 2/3/3b+ and you need a recommended power supply for
# you RPi. No cheap power supply!!! A rainbow will show up if your
# power supply is not capable of suppling the extra current.
# max_usb_current=1

# NOTE: I HAVE A DAEMON CALLED cpupower THAT LOADS WITH SYSTEMD AT BOOT
# THAT IS SET governor='performance'. IT INSTANTLY WILL THROTLE UP THE PI'S
# CPU TO THEIR MAX SAFE CPU SPEED. THERE SHOULD BE NO NEED TO OVERCLOCK
# YOUR PI. I ALSO HAVE THE SWAPINESS SET SO IT WILL USE MORE RAM THAN
# THE DEFAULT BEFORE IT STARTS USING THE /swapfile.

# NO MPEG2 LICENSE FOR OMXPLAYER AS OMXPLAYER WILL NOT WORK ON AARCH64

# decode_MPG2=0x00000000  # NOT VALID WITH VC4

dtparam=audio=on

# VC4 mode

gpu_mem=64
dtoverlay=vc4-kms-v3d,cma-192
avoid_warnings=2

hdmi_drive=2

